Kicker KX150.4 - Kicker KX Amplifier System Diagrams; RCA Dummy Plug Use; Stereo Four Channel Configuration

4
System Diagrams
The following diagrams show the most common configurations for your sys-
tem.
Stereo Four Channel Operation
KX amplifiers are capable of operating into a minimum impedence of 2 ohms
per channel in stereo operation.
SIGNAL IN AMP 1
SIGNAL IN AMP 2
+
-
+
-
+
-
+
-
GROUND
REMOTE
TURN-ON
BATTERY
+12V
FUSE
18"
or less
+
-
RCA Dummy Plugs
SOURCE UNIT
LEFT +
LEFT -
RIGHT -
RIGHT +
LEFT +
LEFT -
RIGHT -
RIGHT +
AMP 1 AMP 2
High-Level
Inputs
Speaker
Outputs
RCA Dummy Plugs
When using both sets of High Level inputs, RCA dummy plugs must be insert-
ed into the AMP 2 inputs in order for the fader to work properly. If the amplifier
is being used in any other configuration do not use the RCA dummy plugs! If
you do not have dummy plugs available, simply using raw RCA ends or cutting
the ends off of existing cables will be sufficient. See the Amplifier Technical
manual for more information. DO NOT USE SHORTING PLUGS!