Need help?Do you have a question about the Kicker SX400.2 and is the answer not in the manual?
General| Channels | 2 |
|---|---|
| Minimum Impedance Bridged | 4 Ohms |
| Minimum Impedance Unbridged | 2 Ohms |
| Input Voltage | 14.4V |
| RMS Power at 4 Ohms | 100 Watts x 2 Channels |
| RMS Power at 2 Ohms | 200 Watts x 2 Channels |
| Bridged RMS Power | 400 Watts x 1 Channel |
| Frequency Response | 20Hz - 20kHz |
| Signal to Noise Ratio | 95dB |
| Crossover Variable Low-Pass | 50Hz - 200Hz |
| Crossover Variable High-Pass | 50Hz - 200Hz |
Information on signal, power, ground wiring, and recommended wire gauge/fuses.
Viewing voltage, temperature, runtime, and fault codes via SickBay.
Setting a personal lock code to secure amplifier settings from unauthorized access.
Adjusting amplifier gain levels and parametric equalizer frequency, bandwidth, and boost/cut.
Adjusting the frequency and slope of the low pass crossover filter.
Adjusting the frequency and slope of the high pass crossover filter.
Choosing between Kompressor settings like Contour, Attack, Red-Line, and Off.
Locking the amplifier to prevent access to settings, allowing only preset recall.
Addressing issues like no output, overheating, shutdown, and weak bass.
Table detailing RMS/Dynamic Power, length, and fuse requirements for each model.
To Next Page
