Kicker SX400.2 - Page 6

11
SX .2 Series Amplifiers
Installation
USING THE SIGNAL OUTPUT JACKS (PAST)
The Output (
P
re
A
mp
S
ignal
T
ransfer) RCA jacks allow you to
send the incoming signal from one Kicker SX series amplifier
to another amplifier or processor without the need for Y
cables. The signal from the
PAST
jacks is identical to the signal
fed to the amplifier via its RCA input jacks and is not affected
by any of the amplifier’s built-in digital signal processing.
Most head units with high voltage outputs should be capa-
ble of driving up to ten amplifiers in a chain.
SOURCE UNIT
To Next Amplifier or Processor
10
SX .2 Series Amplifiers
Installation
STEREO AND MONO SIMULTANEOUSLY (SAMS)
SX.2 series amplifiers are capable of operating into a minimum impedance of 4 ohms
mono and 2 ohms stereo simultaneously with the use of passive crossovers.
R
M1 M2 M3 M4
ESC ENT
HOME
SYS
MEM-1
GAIN EQ LPF HPF KOMP
AMP1
LOCK
MEM-2 MEM-3 MEM-4
PHASE
MUTE
AMP2
LEFT RIGHT
** kicker
RIGHT SPEAKER(S)
LEFT SPEAKER(S)
+
_
+
_
+
_
MONO
SPEAKE
R
HIGH PASS
CROSSOVER
HIGH PASS
CROSSOVER
LOW
PASS
CROSS-
OVER
L+
R-
GROUND
REMOTE
TURN-ON
BATTERY
+12V
FUSE
18"
or less
SIGNAL OUT
SIGNAL IN
R+
L-
These are just a few of the many ways you can use your SX.2 series Kicker amplifier.
These system diagrams are designed to give you a basic understanding of the most com-
mon uses for this amplifier. For more complex systems please visit your local authorized
Kicker dealer. You can also download the SX Technical Manual from our website at
www.kicker.com for more detailed information and complex system diagrams.