GSA-REL Technical Reference Manual 33
Chapter 3
Programming
Summary
This chapter contains configuration and programming instructions for system
programmers. Read the configuration and programming topics that apply to your
fire alarm system.
GSA-REL programming is almost identical for all systems. The greatest
differences exist in the rules required and the configuration of AND groups. The
GSA-REL programming steps require strict adherence. Follow each instruction
carefully.
Content
Programming the GSA-REL in the MIR2-SDU 34
Adding the GSA-REL to the database 34
Creating an abort confirmation LED 36
Programming an AND group 36
Reconciling the Signature map 36
Writing rules for the GSA-REL 37
Programming the GSA-REL in the QS-CU 38
Minimum system requirements 38
Step 1: Read this first 38
Step 2: Add the abort and manual release switch circuits 39
Step 3: Add the two releasing circuits 39
Step 4: Add the two prerelease circuits 39
Step 5: Create a prerelease response 40
Step 6: Create an AND group release response 41
Step 7: Create a manual release response 41
Step 8: Supervise the service disconnect switch 42
Step 9: Indicate active prerelease and release circuits 42
Step 10: Create a drill prerelease response 43
Step 11: Retrieve the loop data from the SLIC 43
Step 12: Reconcile the actual and expected data 43
Step 13: Send the reconciled data to the loop controller 44
To Next Page
Loading...
