17
Battery Information
Alarm Removal
IF TAMPER RESIST FEATURE HAS BEEN ACTIVATED, REFER
TO TAMPER RESIST FEATURE DESCRIPTION ON PAGE 17 FOR
REMOVAL INSTRUCTIONS.
Remove the alarm from the mounting bracket by rotating the
alarm in the direction of the “OFF” arrow on the cover.
Battery (Non-Replaceable)
This alarm contains a sealed 3V Lithium battery, which will last
the life of the alarm. If any form of battery failure is detected,
the red LED light will flash and the unit will "chirp" once every
60 seconds. Also, the green LED will flash twice a second to help
locate the chirping unit (AC power only). This cycle will continue
for at least seven days. Replace alarm immediately!
TTHHEE UUNNIITT MMUUSSTT BBEE DDEEAACCTTIIVVAATTEEDD ((sseeee ““DDeeaaccttiivvaattiioonn ooff
AAllaarrmm”” sseeccttiioonn)) aanndd rreeppllaacceedd wwiitthhiinn 77 ddaayyss ooff tthhee ffiirrsstt
ooccccuurrrreennccee ooff tthhee ““LLooww BBaatttteerryy WWaarrnniinngg”” ttoo pprroovviiddee
ccoonnttiinnuuoouuss aallaarrmm pprrootteeccttiioonn..
If the red LED light flashes along with a chirp every 30
seconds, and if the green LED flashes twice per second (AC
power only) your unit has malfunctioned.
Call our toll free
Product Support Line at 1-800-880-6788 for instructions on how
to return the unit.
End of Life Notification
Ten (10) years after unit is first powered, this alarm will chirp
twice every 30 seconds to indicate it is time to replace the alarm.
REPLACE IMMEDIATELY!
End of Life Hush can be activated by pushing the test
button to silence the End of Life chirp for approximately
3 days at a time for a maximum of 30 day life extension.
To Next Page
Loading...
