• Loud 85 decibel alarm.
• Ionization smoke sensor.
• Powered by 120V AC (60 Hz, 45mA max) wire-in connector .
• Interconnectable to other Kidde/Nighthawk brand smoke and
CO alarms (see page 15 for details).
SMOKE ALARM: The alarm pattern is three long alarm beeps,
which will repeat until the smoke is eliminated. The red LED
light will flash with the alarm beeps..
LOW BATTERY: If the battery is low, the red LED light will flash
and the unit will “chirp” every 60 seconds, for a minimum of
seven (7) days. This alarm contains a sealed 3V Lithium battery,
which will last the life of the alarm. No need to replace
batteries.
• The End of Product Life Alarm/Signal is a double chirp and flash
every 30 seconds (see page 17).
• End of Life Hush. At end of product life, the button can be
pushed to silence the end of life "chirp" for approximately
3 days at a time, for a maximum of 30 days life extension.
• One “chirp” every 30 seconds coupled with a green LED flash
twice a second is an indication that the alarm is
malfunctioning. If this occurs call the Product Support Line at
1-800-880-6788.
• Test/Reset button performs functions.(See page 14).
• HUSH Control Feature that silences the unit during nuisance
alarm situations (see page 15).
• Alarm Memory Feature that gives visual indication when an
alarm has sensed a hazardous condition(see page 16).
• Green and red LED lights that indicate normal operation and
alarm status (see page 17 for details).
The smoke alarm monitors the air for products of combustion
that are produced when something is burning or smoldering.
When smoke particles in the smoke sensor reach a specified
concentration, the alarm warning system will sound, and be
accompanied by the flashing red LED light.
WARNING: PLEASE READ CAREFULLY AND
THOROUGHLY
Features
4
To Next Page
Loading...
Need help?
General
