• Loud 85 decibel alarm.
• Ionization smoke sensor.
• Powered by 120V AC (60 Hz, 45 mA max) wire-in connector
and a sealed 3V Lithium battery backup, which will last the
life of the alarm. No need to replace batteries.
• Interconnectable to other Kidde smoke and CO alarms (see
page 14 for details).
• Alarm warning system that alerts you of the following
conditions in the manner described below:
SMOKE ALARM: The alarm pattern is three long alarm
beeps, which will repeat until the smoke is eliminated. The
red LED light will flash during alarm.
LOW BATTERY: If the battery is low, the red LED light will
flash and the unit will "chirp" once every 60 seconds for a
minimum of seven (7) days. This alarm contains a sealed 3V
Lithium battery, which will last the life of the alarm. No need
to replace batteries.
• The End of Product Life Alarm/Signal is a double chirp and
flash every 30 seconds (see page 17).
• End of Life Hush. At end of product life, the button can be
pushed to silence the end of life "chirp" for approximately
3 days at a time, for a maximum of 30 days life extension.
• One “chirp” every 30 seconds coupled with a green LED flash
twice a second is an indication that the alarm is
malfunctioning. If this occurs call the Product Support Line at
1-800-880-6788.
• Test/Reset button performs functions.(See page 14).
• HUSH Control Feature that silences the unit during nuisance
alarm situations (see page 16).
• Alarm Memory Feature that gives visual indication when an
alarm has sensed a hazardous condition (see page 16).
• Green and red LED lights that indicate normal operation and
alarm status (see page 17 for details).
• Tamper Resist Feature that deters children and others from
removing the alarm (see page 18).
Features
4
To Next Page
Loading...
