K
K
K
K inco
inco
inco
inco -K
-K
-K
-K S
S
S
S series
series
series
series
7
2.2
2.2
2.2
2.2 Functions
Functions
Functions
Functions
2.2.1
2.2.1
2.2.1
2.2.1 CPU
CPU
CPU
CPU Status
Status
Status
Status and
and
and
and LEDs
LEDs
LEDs
LEDs
The CPU has two mode s : STOP mode and RUN mode.
In RUN mode, the CPU executes the main scan cycle and all interrupt tasks.
In STOP mode, the CPU will set all output channels (including DO and AO) to the known values which are
specified in the [ Hardware
Hardware
Hardware
Hardware Configuration
Configuration
Configuration
Configuration ] through Kincobuilder, and only p rocess communication requests
which comes from KincoBuilder software and other Modbus RTU master device.
� Change
Change
Change
Change CPU
CPU
CPU
CPU status
status
status
status
Kinco-K S provides two ways for manually changing the CPU status:
Set all switch of CAN port [ OFF ] ,then PLC will be in STOP status.if any switch is [ ON ] ,PLC will be in RUN
status. (use all 5 switches for KS105,use 1~4 switches for KS105C1,use 1~3 switches for KS105C2.
Using the operation switch (RUN/STOP); Executing [Debug] -> [RUN] or [STOP] menu command in
Kincobuilder.
The following table lists the combined results of these two ways.
Operation
Operation
Operation
Operation Switch
Switch
Switch
Switch Position
Position
Position
Position KincoBuilder
KincoBuilder
KincoBuilder
KincoBuilder command
command
command
command Actual
Actual
Actual
Actual Operation
Operation
Operation
Operation Mode
Mode
Mode
Mode
Some Switch Position
Position
Position
Position is ON
[RUN] RUN
[STOP] STOP
All Switch Position
Position
Position
Position is OFF
[RUN] STOP
[STOP] STOP
Besides, if CPU detects any seriously fault, it will enter STOP status immediately.
� CPU
CPU
CPU
CPU Status
Status
Status
Status LED
LED
LED
LED
The CPU module provides 4 status LEDs: RUN
RUN
RUN
RUN , STOP
STOP
STOP
STOP , Comm.
Comm.
Comm.
Comm. and Err.
Err.
Err.
Err.
Run,
Run,
Run,
Run, Err
Err
Err
Err LEDs show the CPU operation status.
【 Run 】： If CPU is in RUN status,it will turn on. If CPU is in STOP status,it will turn off.
【 Err. 】： If CPU detects error in user program or module, it will turn on.
To Next Page
Loading...
Need help?
General
