Operating Instructions PT 2500 E english / Release 1.0 / 01.12.2009 page 18 of 26
CAUTION!
WHEN REPLACING AN
AGGREGATE THE LINE CORD HAS
TO BE DISCONNECTED FROM THE
POWER SUPPLY
CAUTION!
AT LONGTERM USE AT HIGH LOADS, THE
AGGREGATE & THE COUPLING CAN HEAT UP TO
HIGH TEMPERATURE LEVELS – DANGER OF SKIN
BURN .
3.5 TECHNICAL SPECIFICATIONS
Drive PT 2500 E
motor type universal motor
supply voltage 230 V ~ 100…120 V ~
supply frequency 50/60 Hz
max. speed 30’000 rpm
Speed indication LED, 3 digits, actual speed
Speed measurement Digital, direct by HAL-probe (no calibration
needed)
input power Max. 500 W
output power Max. 280 W
soft-start Yes
noise emission (drive only) lower than 75 dB(A) at 30,000 rpm
direction of rotation clockwise, seen from above
ambient temperature 0 – 40°C
relative humidity 95% max.
certified standards EMC according to:
safety according to:
IEC/EN 61000-6-3
IEC/EN 61000-6-2
IEC/EN 61010-2-51
protection type IP 20
max. period of continuous operation depending on load & speed 100 % duty time
is possible.
Dimensions 157x76x236 mm (LxWxH)
weight drive unit 1.8 kg
To Next Page
Loading...