Operating Instructions PT 2500 E english / Release 1.0 / 01.12.2009 page 11 of 26
IN EVERY CASE THE ELECTRICAL INSTALLATION HAS
TO BE DONE BY TECHNICIAN!
2.4 WARNINGS
Ensure that the rated voltage of the equipment matches
the supply.
Before changing any dispersing aggregate, the line cord
has to be plugged out
When a electrical power blackout occurs, the device has
to be switched- off using the main switch, avoiding the
device to restart automatically.
IT IS IMPORTANT THAT THE MAINS SUPPLY WHERE
THE DEVICE IS PLUGGED IN COMPLIES WITH THE
INFORMATION ON THE TYPE LABEL AND THE
INTERNATIONAL STANDARDS FOR POWER
SUPPLIES. IF NOT, SUCCESSFUL OPERATION
CANNOT BE GUARANTEED
In the event that hazardous chemicals or materials that
endanger health can influence the surroundings or use of
the equipment, appropriate countermeasures must be
taken.
At long term use the aggregate and the coupling may get
hot – danger of skin burn.
To Next Page
Loading...