Operating Instructions PT 2500 E english / Release 1.0 / 01.12.2009 page 19 of 26
4 INSTALLATION
4.1 UNPACK
Open the dispatch box and check that the contents agrees with the delivery note.
CHECK ALL PARTS FOR POSSIBLE TRANSPORT
DAMAGE. INFORM US OR YOUR DEALER IMMEDIATELY
ABOUT ANY DISAGREEMENT OR FAULT. IF POSSIBLE
SEND US DIGITAL PHOTOS BY EMAIL TO
LABORATORY@KINEMATICA.CH
.
4.2 ASSEMBLING OF THE DRIVE
The PT 2500 E drive arrives fully equipped with the extension suitable for the stand
ST-P11/600 or ST-P20/600. Just mount the drive at the stand and plug the line cord into
the power inlet connection at the back side.
4.3 ASSEMBLING OF THE STAND WITH ACCESSORIES
See assembly instruction / manual supplied with the stand.
4.4 STARTING UP
Ensure that the voltage marked on the type label complies with your power supply
Immerse the aggregate in the product. The optimum depth of immersion of the
dispersion attachment is about 70 % of the total depth of product in the container.
Never immerse the upper coupling head and upper hole of the dispersion aggregate.
Turn on at the main switch.
Set the desired speed using the turning knob
To Next Page
Loading...