Kinetico Kube - Installation - Kinetico Carina 3 Way Tap

14
Kube Drinking Water Filter
Installation Instructions
Visit: kubewater.co.uk
Pantone 1235 Pantone 185 Pantone Process Blue Pantone 360 Pantone Cool Grey 10
WARNING: Do not use tools to tighten the flexible
pipes to the low part of the tap, this may cause them
to become damaged.
Installation: Kinetico
Carina 3 way tap
WORK TOP
RUBBER WASHER
TAP ADAPTOR
COLD WATER
HOT WATER
METAL WASHER
NUT
ESCUTCHEON
RUBBER WASHER
TAP
STEP 1
Drill the hole
Drill a 36mm ø hole in the appropriate location.
STEP 2
Fix the tap
Slide the escutcheon up the pipework to the
bottom of the tap. Screw the fixing bolts into
the bottom of the tap. Place the pipework
through the hole. Slide the rubber and metal
washer over the pipework. Screw and tighten
the two nuts on the fixing bolts, securing the
tap to the work surface.
STEP 3
Attach the tap adaptors
Attach the two 15mm adaptors to the bottom
of the hot and cold pipes and attach the 3/8" -
1/4" adaptor.
STEP 4
Connect the outlet tubing
Push the cut length of tubing all the way into
the tap adaptor. Pull back to check it is secure.
STEP 5
Flush the system
To complete the installation process, turn the
tap and flush the system for 5 minutes.