Kinetico Kube - Taking It With You; Disconnecting and Packing Kube; Reconnect Supply Line

12
Kube Drinking Water Filter
Installation Instructions
Visit: kubewater.co.uk
Pantone 1235 Pantone 185 Pantone Process Blue Pantone 360 Pantone Cool Grey 10
STEP 1
Drill the hole
Drill a 12mm ø hole in the appropriate location.
STEP 2
Fix the tap
Slide the rubber insert over the thread and place
neatly inside the recess under the body of the
tap. Insert the tap through the worktop. Slide
on the rubber washer, metal washer, star washer
and nut. Tighten the fixings and ensure the tap is
in the correct position before final tightening.
Installation:
Kinetico 1 way tap
STEP 3
Attach the tap adaptor
Screw tap adaptor firmly onto the thread to
ensure the rubber seal is water tight.
STEP 4
Connect the outlet tubing
Push the cut length of tubing all the way into
the tap adaptor. Pull back to check it is secure.
STEP 5
Flush the system
To complete the installation process, turn the
tap and flush the system for 5 minutes.
WORKTOP
TAP BODY
RUBBER INSERT
RUBBER WASHER
METAL WASHER
STAR WASHER
NUT WASHER
TAP THREAD
TAP ADAPTOR