7
Replacing a Reservoir, FROG
®
BAM
TM
and Bac Pac
Reservoirs MUST be Replaced Every Season
Replacing a Reservoir, FROG
®
BAM
TM
and Bac Pac ...........continued page 8
SLOT IN
RESERVOIR
FIN INSIDE
OF CYCLER
1.
6.
8.
2. 3.
4.
5.
7. 9.
REPLACEMENT
MINERAL RESERVOIR
REPLACEMENT
MINERAL RESERVOIR
• Check the back of the
Reservoir box and back label
of Reservoir itself to make
sure you have the correct
POOL FROG
®
Reservoir to fit
your POOL FROG
®
Cycler.
* RESERVOIRS MUST BE
REPLACED EVERY SEASON.
• Open
the box
and pull
out the
Flow
Control
Pac.
• Then reach in and remove the
Reservoir. Please note: complete
instructions for inserting a Reservoir,
FROG
®
BAM
TM
and Bac Pac are included
inside the Reservoir box.
CAUTION read carefully -
• USE ONLY the factory recommended replacement Reservoir,
FROG
®
BAM
TM
and Bac Pac. DO NOT USE any other Pac or bulk
chemical tablets in the Cycler. Use of any other product
could result in damage to pool equipment or surface, unsafe
pool conditions, fire or explosion. Warranty will be void if
the correct Reservoir, FROG
®
BAM
TM
and Bac Pac are not used.
• Turn off pump.
• Unscrew drain valve to
relieve pressure.
• Use the cap tool included
with Cycler to loosen cap
by hitting the handle with
the flat of your hand
counter clockwise. If using
the Bac Pac stand back to
avoid inhaling chlorine
fumes.
• Find slot on side of
Reservoir and line up with
fin inside the Cycler. Lower
Reservoir into Cycler until
secure.
• Turn dial to Pac Removal.
This reduces the flow of
water into the unit when the
cap is open.
Contents:
Series #5100
(up to 20,000 gallons)
Series #5200
(up to 20,000 gallons)
Series #5400
(up to 40,000 gallons)
Series #5600
(up to 40,000 gallons)
To Next Page
Loading...
