PAC
TOWERS
PAC
TOWERS
19.
20.
21.
22.
23.
24.
25.
18.
• To remove
Bac Pac end
caps, grab
onto the lip of
one cap with
a pliers and
pull up until
cap releases.
Repeat the
process to the
other cap.
• Turn Bac Pac over and
shake slightly until tablets
fall into tower areas.
• Line up the small leg of the Bac
Pac with the small opening in the
Reservoir and the large leg with
the large opening. Lower Bac Pac
into Reservoir until secure.
• Avoid sparks, open flame
or smoking when handling
the Bac Pac.
• Replace cap by hand only.
DO NOT OVER TIGHTEN.
• DO NOT USE CAP TOOL TO
TIGHTEN CAP.
Use for removal only.
• Check that drain valve is
screwed in.
• For easy reminders, place a POOL FROG
®
reminder sticker
on your calendar to mark the six month replacement of the
Reservoir and approximate replacement times for the Bac
Pac. Reminder stickers found in Reservoir box.
For winter climate pools, replace Reservoir next spring.
DO NOT use the same Reservoir from season to season. The
Reservoir will be ineffective if dried out and used later, even
if it was not used for a full 6 months.
Using the Bac Pac
• For low
level chlorine
support,
discard or
recycle the
Flow Control
Pac and
replace with
a Bac Pac.
9
BAC PAC
RESERVOIR
End caps
To Next Page
Loading...
