Kingfisher FPCSP46-2 - Page 33

33
FPCSP46-2
In more detail . . .
Operation
Engine cold start
1. Place the saw where it does not come into contact with any objects.
2. Engage the chain brake.
3. Set stop switch (12) to I (Fig. 21).
4. Press the primer (8) until the bubble is lled with fuel (6-8 times) (Fig. 22).
5. Pull out the choke knob (7) (Fig. 23).
21
12
22
8
23
7
6.
Hold the product securely to the
ground. Place your left hand on the
front handle (5) and additionally
secure it with your right foot (Fig. 24).
7. Pull the recoil starter handle (15)
slowly with your right hand until you
feel a denite resistance and then
give it a brisk, strong pull. Repeat
until the engine attempts to start but
no more than 4 times.
8. Press in the choke knob (7) fully.
9. Pull the recoil starter handle (15)
briskly and strongly. Repeat until
the engine starts.
10. Squeeze the throttle trigger lock-out (9) and throttle trigger (11) and release them.
11. Let the product run in idle for 10 to 15 seconds to let it warm up.
12. Push the front hand guard (4) to check if the chain brake works properly. Then
disengage the chain brake.
13. To start cutting, grip the product with both hands, left hand holding the front handle (5)
(do not hold the front hand guard) and the right hand holding the rear handle (10).
24
5
15