22
STORAGE SAFETY continued…
• The fertilizers are generally corrosive. For this reason it is important that
no particles of fertilizer remains on the seeder/spreader for long periods of
time.
• Wash the hopper and seeder thoroughly when planning to store.
• Lubricate to prevent moisture damage and rust during storage.
• Sand areas where paint is chipped or worn and repaint to prevent rust.
NOTE: To distribute product more uniformly, operate spreader only on calm (non
windy) days.
NOTE: To ensure full coverage (without skips), set spreader to disperse product at
half the rate and go over the field plot twice using a 2nd pattern that crosses the
first pattern.
ADJUSTMENTS
Distributor Vane Adjustment
Product distribution varies depending on travel speed, radius of distribution, and
roughness of terrain. Also specific gravity, quality, and humidity of the product can
effect distribution. To help ensure even distribution, the operator can adjust the
distributor vanes to different hole locations on the spreader disc.
Refer to Figure 3: Page 23
When all vanes are placed in hole #1, distribution of product to the left is
increased. If inserted into hole #4, distribution to the right is increases.
Final adjustment of the vanes depends upon the type of material being used and
the operator’s experience.
1. Loosen bolt (#1).
2. Rotate distributor vanes (#2) to desired hole position.
3. Tighten bolts.
To Next Page
Loading...
Need help?
General
