26
Dispersal Pattern
Refer to Figure 3-1, Figure 3-2 & Figure 3-3:
Product dispersal is controlled by properly opening and closing left and right gates at the
hopper bottom with adjustment levers (#1 & #2). Some adjustment to the distributor vanes
may be required. See detailed instructions for “Distributor Vane Adjustment” on page 22
& 23.
Positioning right and left gate levers as follows:
Left Side Dispersal, View (A) in Figure 3-1
Refer to Figure 3-3:
1. Remove lever locking knob (#3).
2. Close right gate by moving adjustment lever (#1) above gate setting position #1.
3. Move adjustment lever (#2) to the selected gate setting provided in spread chart.
4. Secure adjustment lever (#2) by placing hair pin cotter (#5) in the selected gate setting
hole with adjustment lever (#2) resting on top of hairpin (#5).
Full Width Dispersal, View (B) in Figure 3-1
Refer to Figure 3-2 & Figure 3-3:
1. Lock adjustment levers (#1 & #2) together with lever locking knob (#3).
2. Move adjustment levers together just above selected gate setting provided in spread
chart.
3. Secure adjustment levers by placing hair pin cotter (#5) in the selected gate setting hole
with adjustment levers resting on top of hairpin (#5).
Right Side Dispersal, View (C) in Figure 3-1
Refer to Figure 3-3:
1. Remove lever locking knob (#3).
2. Close left gate by moving adjustment lever (#2) up above gate setting position #1.
3. Move adjustment lever (#1) to the selected gate setting provided in spread chart.
4. Secure adjustment lever (#1) by placing hair pin cotter (#5) in the selected gate setting
hole with adjustment lever (#1) resting on top of hairpin (#5).
To Next Page
Loading...