① Clean the windshield with a dry cloth.
② Remove the electrostatic sticker film and apply the sticker to the windshield
while making sure there are no air bubbles.
③ Peel off the film on one side of the double-sided adhesive tape and apply the
tape to the D6 Dash Cam.
④ Peel off the film on the other side of the adhesive tape and press the D6 Dash
Cam firmly to secure it on the electrostatic sticker (if you wish to remove the
dash cam, please take off the electrostatic sticker).
Note: You can stick the dash cam to the windshield without using the electrostatic
sticker.
⑤ Connect the USB power cable into the USB power port of the dash cam, then
plug the car charger into the cigarette lighter socket.
⑥ Use the pry tool to hide the cables.
12.4 Install the D6 Dash Cam to the windshield.
Cable clip
Electrostatic
sticker
GPS
01 02 03 04 05 06
07 08 09 10 11 12
13
14 15 16 17 18 19 20
21 22 23 24 25 26 27
28 29 30 31 32
To Next Page
Loading...
