(1) Turn Signal Lamp Bulb
3. With the bulb pressed downward,
turn it counterclockwise to remove
it. Replace it with a new one.
Do not touch the bulb if it is
still illuminated or right after
it is turned "OFF". You can be
burned by the hot bulb.
For some bulbs which require
delicate handling or work pro-
cess, contact your local KIOTI
Dealer.
Do not touch the illuminating
glass part of the halogen bulb.
The bulb life can be shortened
by nger prints, dust and mois-
ture, or the bulb even can be
broken. Clean it with soft cloth.
The halogen bulb contains
compressed gas, so it can ex-
plode if dropping or scratching
it. Therefore, never use a bulb if
it is scratched or was dropped.
CAUTION
tb3O717A
When separating the cover by
prying it "OFF" with a screw-
driver, be careful not to dam-
age it.
Before replacing a bulb, make
sure to put the key switch and
the switch for the correspond-
ing bulb to the "OFF" position.
Install a new bulb with the
same capacity after removing
the installed bulb.
CAUTION
To Next Page
Loading...
Need help?
General
