Take the following actions in the
event the coolant temperature reach-
es the boiling point, what is called
"Over-heating".
1. Stop the machine in a safe place
and keep the engine idling.
2. After 5 minutes of unloaded idling,
shut the engine down.
3. Keep yourself away from the trac-
tor for another 10 minutes or until
steam has stopped blowing out of
the engine.
4. Make sure that there is not danger
and repair the cause of the over-
heating according to the manual’s
instruction.
(1) Power Steering Oil Line (2) Connect
1.
Check to see that all hydraulic lines and
hose ttings are tight and undamaged.
2. If damage is found you should re-
place the hoses at once.
T11O717A
1. Stop the engine and apply the
parking brake.
2. Unscrew the nuts (B) and (D) and
press the middle of the belt with
force of 10 kg/f. Adjust the belt ten-
sion to the specification with the
nut (C). Then, tighten the nuts (B)
and (D).
(1) Air Conditioner Belt
(A) Tension Amount (B) Mounting Nut
(C) Adjustment Nut (D) Lock Nut
AIR CONDITIONER BELT TEN-
SION (AA)
fan belt tension (A)
10~12 mm ( 0.39~0.47 in.)
T11O718A
To Next Page
Loading...
