PROBLEM POSSIBLE CAUSE CORRECTION
3. Slow or erratic lift
Control valve leaking inter-
nally. (Bypassing uid within
valve.)
Replace control valve and recheck operation.
Inadequate hydraulic pump
capacity.
Refer to "Hydraulic Pump Capacity Inadequate."
4. Inadequate lifting capacity
Engine R.P.M. too slow.
Increase engine R.P.M.
Excessive load-material
weight exceeds specied
loader capacity.
Reduce Load
Relief valve setting below
specications.
Check and reset relief valve setting as needed.
Lift cylinder piston assembly
leakage.
Check cylinders for leakage.
Repair as needed.
Control valve leaking inter-
nally.
Replace control valve and recheck operation.
Hydraulic pump defective.
Refer to "Hydraulic Pump Capacity Inadequate."
5. Aeration of Hydraulic Fluid
(generally indicated by foamy
appearance of uid).
Low hydraulic uid level.
Check and rell hydraulic system to proper level.
Air leaking into suction side of
hydraulic pump.
Check for loose or defective connections between reservoir
and hydraulic pump.
Hydraulic uid foaming due to
improper hydraulic oil usage.
Refer to Tractor Operator's Manual and replace hydraulic oil
using recommended hydraulic oil.