KIPI eSTER_x40 Series - Installation and Service Settings

KIPI eSTER_x40 Series

44 pages

Save Page as PDF

To Next Page

To Next Page

To Previous Page

To Previous Page

Loading...

19

INSTALLATION AND SERVICE SETTINGS

ecoMAX360P1-C

Table of Contents

Default Chapter3
- Table of Contents3
1 Recommendations Regarding Safety4
2 General Information5
3 Information about Documentation5
4 Storage of Documentation5
5 Applied Symbols5
6 Directive Weee 2012/19/Ue5
User Settings7
7 User Menu - Structure8
8 The Controller Support9
- Description of the Controller Support9
- Description of the Main Screen9
- The Controller Start-Up10
- Preset Temperature Setting10
- Firing up Mode10
- Operation Mode10
- Regulation Modes11
- Supervision Mode11
- Burning off Mode12
- Stop Mode12
- Grate12
- Burner Cleaning12
- Huw Settings12
- Huw Preset Temperature Settings13
- Hysteresis of Huw13
- SUMMER Function Start-Up13
- Huw Container Disinfection13
- Mixer Circle Settings13
- Weather Control14
- Night Decrease Settings Description15
- Working According to Schedule15
- Circulation Pump Control15
- Fuel Level Configuration16
- Feeder Test16
- Information16
- Manual Control16
- Room Panel17
- Cooperation with the Internet Module17
Installation and Service Settings19
9 Hydraulic Schemes20
10 Technical Data23
11 Conditions of Storage and Transport23
12 The Controller Installation23
- Environmental Conditions23
- Installation Requirements23
- Installation of Module23
- Connecting Electrical System24
- Electric Scheme26
- Connection of Temperature Sensors28
- Connecting Weather Sensor28
- Temperature Sensors Checking29
- Optical Sensor Connection29
- Mixers Room Temperature Connection29
- Connection of Reserve Boiler29
- Connection of Alarm Signaling30
- Mixer Connection31
- Connecting of Circulation Pump31
- Connecting of Safety Temperature Limiter31
- Thermal Protection32
- Connecting of Room Thermostat32
- Connecting of Internet Module33
13 Service Menu - Structure34
14 Description of Service Parameters35
- Burner35
- Boiler36
- And Huw36
- Buffer37
- Mixer37
- Other Parameters38
15 Alarms Descriptions39
- Boiler Max39
  - Oiler Max Temp Exceeding39
- Burner Max39
  - Urner Max Temp Exceeding39
- Boiler Temp39
  - Oiler Temp Sensor Damage39
- Feeder Temp39
  - Eeder Temp Sensor Damage39
- Overheating Boiler, STB Open Contact39
- Preventive Cooling40
- Pump Anti Standstill Function40
17 Replacement of Components40
- Fuse Replacement40
- Software Replacement40
18 Possible Faults Description41