5
2 General information
The controller ecoMAX360P1-C is a device
designed to control the operation of a boiler
with automatic feeding of solid fuel with a
igniter. Flame detection is performed with
the use of an optical flame brightness sensor.
It can control the work of central heating and
hot water circuits and also control the work
of mixing heating circuits. The required
temperature of heating circuits can be set on
the basis of data obtained from the weather
sensor. The possibility of cooperation with
room thermostats, separate for each heating
circuit is beneficial for maintaining
comfortable temperature in heating rooms.
The controller may operate in connection
with additional wire room thermostat/panel
ecoSTER200, ecoSTER TOUCH and wireless
room thermostat/panel eSTER_x80 or
eSTER_x40 installed in rooms and
ecoNET300 Web module. Additionally it
cooperates with extension B module.
The controller may be used in households
and other similar premises and in light
industry facilities.
3 Information about documentation
The controller manual is a supplement for
the boiler manual. In particular, except for
this manual, the boiler manual should also be
observed. The controller manual is divided
into two parts: for user and fitter. Yet, both
parts contain important information,
significant for safety issues, hence the user
should read both parts of the manual.
We are not responsible for any damages
caused by failure to observe these
instructions.
4 Storage of documentation
This assembly and operation manual, as well
as any other applicable documentation,
should be stored diligently, so that it was
available at any time. In the case of removal
or sale of the device, the attached
documentation should be handed over to the
new user / owner.
5 Applied symbols
In this manual the following graphic symbols
are used:
- useful information and tips,
- important information, failure to
observe these can cause damage of
property, threat for human and
household animal health and life.
Caution: the symbols indicate important
information, in order to make the manual
more lucid. Yet, this does not exempt the
user from the obligation to comply with
requirements which are not marked with a
graphic symbol!
6 Directive WEEE 2012/19/UE
Purchased product is designed and made of
materials of highest quality. The product
meets the requirements of the Directive
2012/19/EU of 4 July 2012 on waste
electrical and electronic equipment
(WEEE), according to which it is marked by
the symbol of crossed-out wheeled bin (like
below), meaning that product is subjected to
separate collection.
Responsibilities after finishing a period of
using product:
• dispose of the packaging and product at
the end of their period of use in an
appropriate recycling facility,
• do not dispose of the product with other
unsorted waste,
• do not burn the product.
By adhering obligations of waste electrical
and electronic equipment controlled disposal
mentioned above, you avoid harmful.
To Next Page
Loading...