KIPI eSTER_x40 Series - 13 Service Menu - Structure

34
13 Service menu – structure
Entering the service menu requires
entering the password.
Service settings
Burner settings
Boiler settings
CH and HUW settings
Buffer settings*
Mixer settings 1-2*
Buffer settings*
Show advanced setup
Service counters
Restore service settings
Save serv.set.
Log out
Output H (mod B)
Burner settings
Firing-up
• Ignition test time
• Fuel dose
• Flame detection
• Firing-up airflow
• Firing-up time
• Blowing after firing up
• Heating up time
• Worktime with min. power
• Pulsation
Operation
• Thermostat mode
• Cycle time OPERAT.
• Fuel calorific
• Capacity of tank
Burning off
• Burning off max. time
• Burning off min. time
• Air flush intensity
• Air flush period
• Air flush interval
• Air flush start
• Air flush stop
Cleaning
• Poker p.before inflame
• Poker p.after bur.off
• Cleaning airflow
• Rotary cleaning cycle
Supervision
• Supervision time
• Boiler output
• Cycle time
• Blow-in output
Grate *
• Flush time Superv.
• Flush period Sup.
Min. airflow output
Fuel detection time
Max. burner temp.
Boiler settings
Thermostat select.
Min. boiler temp.
Max. boiler temp.
Boiler cooling temperature
Thermostat function
• Off burner
• Off pump
• Off all
Exch.clean alarm
Reserve boiler*
Parameter A,B,C FL*
CH and HUW settings
CH activation temp.
CH stand.load.HUW*
Min. HUW temp. *
Max. HUW temp. *
Boiler inc. by HUW and M.
HUW operation extension*
Circul. standstill time*
Circul. operation time*
Circul. activation temp.*
Exchanger*
Buffer settings *
Buffer support
Loading start temp.
Loading stop temp.
Mixer settings 1-2*
Mixer support
• Off, CH on, Floor on, Pump only
Thermostat selected*
Min. mixer temp.
Max. mixer temp.
Proportional range
Integration time constant
Valve opening time
Pump off by therm.
Mixer input dead zone*
Output H (mod B)
OFF
Cleaning
• Cleaning time, Cleaning pause
Alarm
Reserve boiler
* not available if proper sensor not attached,
extension module or parameter is hidden.