signaling.
3)Press [OK] or [PTT] to keep the setting; press[CLR] to exit and
quit the setting.
4)If CTCSS has been set, CT appears on the LCD while receiv-
ing; If DCS has been set, DCS appears.
Change the CTCSS / DCS Code for Channel Transmitting:
1)Press [F], [8].
CTCSS / DCS code or OFF appear on the screen.
2)Press [MENU] to switch between CTCSS and DCS.
While selecting CTCSS, TC and CTCSS code appear. Rotate the
Channel Selector to select the desired CTCSS code, OFF means
no CTCSS / DCS signaling.
While selecting DCS, TD and DCS code appear. Rotate the Cha-
nnel Selector to select the desired DCS code, press [F] to select the
positive or negative code. OFF means no CTCSS / DCS
signaling.
3)Press [OK] or [PTT] to keep the setting; press [CLR] to exit and
quit the setting.
4)If CTCSS has been set, CT appears on the LCD while transm-
itting; If DCS has been set, DCS appears.
Offset Frequency Setting
In the full-frequency display mode, offset frequency setting is
available. Offset frequency setting makes the transmission
frequency higher(+) or lower(-) than the received frequency to
increase communication range by a repeater.
1)Press [F], [4]. Rotate the Channel Selector to select offset
frequency or OFF . If + offset frequency is selected, +
appears on the screen; if - offset frequency is selected, -
appears; if OFF is selected, the frequency for transmitting
and receiving will be the same.
2)Press [OK] or [PTT] to keep the setting; press [CLR] to exit and
quit the setting.
3)Press [F], [5] and rotate the Channel Selector or input the offset
frequency directly by the keypad. The range 00.000
37.995MHz is available.
4)Press [OK] or [PTT] to keep the setting; press [CLR] to exit and
quit the setting.
Deleting Memory Channel
1)In the memory frequency mode, select the desired channel (the
channel is not locked out).
2)Press and hold [CLR] for 2 seconds, LCD display DEL-? .
3)Press [OK] or [PTT] again to delete the selected channel.
Deleting All the Memory Channels
1)Switch off power.
2)Press [CLR] and meanwhile rotate the Power/Volume Switch to
switch on power, LCD display AL.DEL? .
3)Press [OK] or [PTT] again to delete all the memory channels.
Channel Lockout
Channel Lockout is to avoid the channel being deleted or covered.
1)In the memory frequency mode, select the desired channel.
2)Press [F], [MENU], appears below the channel number to
show that the channel has been locked out.
3)To unlock, press [F], [MENU] again.
14
13
To Next Page
Loading...
Need help?
General
