Selecting Scan Resume Method
Before scanning, it is necessary to decide how to continue scan-
ning after detecting a signal.
The transceiver stops scanning when detecting a signal, remains
there for 5 seconds, and then continues to scan even if the signal is
still present.
The transceiver stops scanning when detecting a signal until the
signal drops out. There is a 5 seconds delay between signal drop-
out and scan resumption unless the transceiver detects a new
signal during this time.
The transceiver stops scanning when detecting a signal and pauses on
the channel, and remains there even if the signal has disappeared.
Please select the first item in the menu setting to set a scan
method.
Memory Scan
In the memory frequency mode or channel mode, memory scanning is
available.
1) Press [SCN] to start scanning.
2) Scan starts at the frequency currently displayed and increases.
3)To reverse the scan direction, rotate the Channel Selector clockwise
or counterclockwise.
4)To end the scan and return to the stand-by channel, press any key
other than [MONI]. Press and hold [MONI], the transceiver will work
on the current channel; release for 5 seconds, continue to scan.
Note:
The basic requirement for memory scanning: minimum need 2 or
more memory channels which have been set and not to be locked.
The squelch must be closed for scan to function.
Frequency Scan
In the full-frequency display mode, frequency scanning is available.
1)Press [SCN] to start scanning.
2)Scan starts at the frequency currently displayed and steadily incre-
ases according to the step .
3)To reverse the scan direction, rotate the Channel Selector clockwise
or counterclockwise.
4)To end the scan and return to the stand-by channel, press any key
other than [MONI], [PTT].
Press [PTT], the transceiver will work at the current frequency and
exit the scan.
Press [MONI], the transceiver will work at the current frequency, release
for 5 seconds, continue to scan.
Time-out Timer (TOT)
The purpose of the Time-out Timer is to prevent any single person from
using a channel for an extended period of time. If the continuously
transmission time overruns the limited time, the transceiver will stop
transmitting and give out a warning tone.
The limited time can be set by the second item in the menu setting
(unit: second)
16
15
7. Scan
Time-operated Mode (TO)
Carrier-operated Mode (CO)
Search-operated Mode (SE)
8. Auxiliary Functions
.
To Next Page
Loading...
Need help?
General
