PT6500 User’s Manual
Page 16 of 30
7. stands for the radix point, press ＃ to convert among CTCSS、DCS and
reverse DCS.
Set contact list：
1．As shown: in CH 1 , press
to enter select mode,
2. Press / , and contact list is shown,
3. Press to select,
4. Select the address cable of the call to be made with / ,
5．Check the alias or address code by turning the knob,
6. Key in the address code of the person you are calling,
7. Press
to transmit the current contact list.
Set status:
1．As shown: in CH 1 , press
to enter select mode,
2. Press / , and status is shown,
3. Press to select,
4.Select the needed status with / ,
5．Check the alias or address code of the status by turning the knob,
6. Press
to select the current status.
■Programmable Button functions
The dealer can program the 2 Side Buttons and 1 top Button with one of the following auxiliary
functions.
None
Off (“do not set the functions”)
Scan
Separate working
*
To Next Page
Loading...
