Why is the standby time short after fully charging my Kirisun Transceiver?
If the standby time is short even after a full charge, it's likely that the battery life is ending. Please replace it with a new one.
What to do if I am unable to talk with others in the same group using my Kirisun Transceiver?
If you are unable to communicate with others in your group, it might be because you are out of the communication range. To resolve this, try using a different frequency or CTCSS/DCS. Please reset your Kirisun Transceiver.
Why can I hear other voices (not from the same group) in the channel on my Kirisun Transceiver?
You might be hearing voices from outside your group because of the frequency or CTCSS settings. Please change the frequency or CTCSS and ensure the settings are consistent across all transceivers within your group.
How to fix a Kirisun Transceiver that can't switch on?
If your Kirisun Transceiver won't switch on, it could be due to: * Low battery power: Charge or replace the battery. * Poor battery connection: Remove and then reload the battery to ensure it's properly connected.
General| Frequency Range | 400-470MHz |
|---|---|
| Channel Capacity | 16 |
| Dimensions | 100mm×55mm×32mm (without antenna) |
| Weight | 220g (with battery and antenna) |
| Audio Output | 500 mW |
| IP Rating | IP54 |
| RF Output Power | 5 W |
| Operating Voltage | 7.4 V DC |
To Next Page
