Why is my Kirisun PT8200 Transceiver not turning on?
Your Kirisun Transceiver might fail to power on because the power cable isn't properly connected, the power cable's protective tube is burnt out, or the power button has poor contact. Ensure the power cable is securely connected. If that doesn't work, replace the burnt protective tube or the silica gel/PCB button.
What to do if my Kirisun PT8200 red transmission indicator lights up but no sound is heard?
If the red transmission indicator lights up but you hear no sound, the power-amplifier tube Q23/Q25, the microphone, or the power amplifier U201 might be broken. Please change the broken part.
Why is my Kirisun PT8200 phase lock loop unlocked and beeping?
If your Kirisun Transceiver's phase lock loop is unlocked and beeping, the crystal X1, oscillator tube, or IC U101 of the phase lock loop might be broken. Replacing the broken component should resolve the issue.
What to do if my Kirisun PT8200 Transceiver has no receiving signal?
If you're not getting any receiving signal on your Kirisun Transceiver, it could be due to several reasons: * The antenna might not be properly connected - try fastening the antenna head. * The high-frequency amplifying tube Q26 or the mixed tube Q21 could be broken - consider replacing them. * The squelch level might be set too high - try resetting it.
What to do if my Kirisun PT8200 green receiving indicator lights up but no sound is heard?
If the green receiving indicator lights up on your Kirisun Transceiver but you don't hear any sound, the speaker or the audio power amplifier U11 might be broken. Please change the speaker or IC.
How to fix no talkback on Kirisun PT8200 Transceiver?
If you're experiencing no talkback with your Kirisun Transceiver, ensure the frequency is correct by reselecting the channel with the same frequency. Also, verify that the CTCSS/DCS code is the same and reset it if necessary. Please check the TX/RX signalling system of both. Note that it may be out of the effective communication range.
General| Brand | Kirisun |
|---|---|
| Model | PT8200 |
| Category | Transceiver |
| Language | English |
Lists the accessories included in the package for inspection.
Details on connecting the power cable and preparing for radio installation.
Instructions for securely mounting the radio unit using the provided bracket and screws.
Details the external components of the radio, including buttons and indicators.
Explains the indicators and signal strength representation on the radio's display.
Identifies the various interfaces and connectors located on the rear of the radio.
Instructions for sending and receiving selective calls using specific call lists.
Explains how to respond to and manage incoming call alerts, including callback options.
Describes methods to activate or deactivate the channel scanning feature.
Explains how to temporarily remove noisy or interfering channels from the scan list.
Provides instructions for adding, deleting, and setting priority channels within the scan list.
To Next Page
