6
H means the transmission of signal for the
radio at the high power;
Display Description
Call Received indicator.
The radio receives a selective call/call alert.
Monitor State Indicator.
Scan Indicator.
Companding Indicator.
Talkaround Indicator.
Scrambler Indicator.
OST Indicator.
2.3 Rear Panel
1 Antenna Interface
2 Power Interface
3 15-Pin Connector for accessories.
4 External Speaker Interface
3 Basic Operation
1.Startup:
Press the red POWER button for a long time (at least 1.5
seconds) to switch the radio on/off
2.Volume
Press the MONITOR or Squelch button to listen to
the background noise first, and then adjust the volume by
turning the volume control knob.
3.Channel
The radio can provide 128 conventional channels (There are
totally 16 groups and each has at most 16 channels).
Press the CHANNEL UP or CHANNEL DOWN button
to select the channel. Press the ZONE UP or ZONE
DOWN button to select the group you require.
4.Transmission
To send a call, press the PTT button and speak to the
microphone in the normal voice. Please keep the microphone
about 3 or 4 cm far from your mouth. After speaking, please
loosen the PTT button.
5. Receive
The radio will return to the receiving state after you loosen the
PTT button.
The distributor may have set the CTCSS/DCS signalling in the
programmed radio of your radio. On the channels with CTCS
S/DCS are set, you can only hear the call from other radio with
the same CTCSS/DCS.
To Next Page
Loading...
Need help?
General
