15
16
During sweep, the red indicator will flicker. When the scan is
landed on, the indicator will stop flickering.
1.Enter the scan state through menu mode.
A.Press the Menu Selection/Enter button to enter the
menu mode.
B.Press / button until SYS SCAN .
C.Press button for selection.
D.Press / button until SCAN ON? or SCAN OF?
E.Press button for select.
2.Use the scan button.
A.Press SCAN button to activate the scan function.
B.Press SCAN button again to disable the scan function.
9.2 Nuisance Delete
If a channel continuously generates noise or interference, press
the button to remove this channel from the scan list temporarily.
Note: the priority channel can't be removed and the last one in the
scan list, either.
9.3 Edit Scan List
9.3.1 Add or Delete the Channels in the Scan List
A.Press the Menu Selection/Enter button to enter the menu
mode.
B.Press / button until PROG LST .
C.Press button to select SCAN LIST .
D.Press / button until ADD LST? or DEL LST? .
E.Press button for selection.
F.Press / button until the channel you want to add or
9.3.2 Set Priority Channel
1.Press the Menu Selection/Enter button to enter the menu
mode.
2.Press / button until PROG LST .
3.Press button to select SCAN LIST .
delete.
G.Press button to complete operation you will see CHN
SAVE (If you added a channel)or CHN DEL .
H.Press button to return to the previous operation.
4.Press / button until ED PRIO? .
5.Press button for selection.
6.Press / button until PRIO#1? or PRIO#2? .
7.Press button to select the type of the required priority channel.
For example, in Step 7, the type of priority channel is DES? .
Press / button to select the required priority channel.
8.Press button to complete operation.
9.Press button to return to the previous operation.
10. OST
In a certain specific channel, you can revise the CTCSS/DCS
encode/decode setup of current channel.
The operating steps go as follows:
A.Press the OST button to enter the OST menu mode.
B.Press / button until the CTCSS/DCS encode/decode you
want.
C.Press button to select .
To Next Page
Loading...
