13
14
8. Utilities
The item can help you customize some setups of the radio.
The operating steps go as follows:
A.Press the Menu Selection/Enter button to enter the menu
mode.
B.Press / button until UTILITY .
C.Press button for selection.
D.Press / button until the items you require are showed.
E.Press button for select. The radio will show the current setup.
F.Press / button to show all items that can be set with this
item.
G.Press button to select this setup.
H.Press button to return to the previous operation.
Change the setup items in the following table as per the
previous steps.
Items Selectable Setups Functions
Squelch Level
SQL LEV
Transmission
Power
PWR LEV
VOX Level
VOX LEV
Backlight
BACK LED .
MCU software
version
display
SOFT VER
SQL 0 ~ 9
Change the squelch level of the
radio.
PWR LOW
PWR MID
PWR HI
Select transmission power among
high, medium and low levels.
VOX 0 ~ 9
Change the VOX level of the
radio.
BLED OFF
BLED ON
BL AUTO
Select among such modes of
backlight as turnoff , normal
turn-on or auto
Eg R01.00
Show the software version.
B.Press / button until RPTRTALK .
C.Press button for selection.
D.Press / button until REPEATE or TALKRND .
E.Press button for confirmation.
2. Switch the talkaround or repeater mode through talkaround
button.
9. Scan
In order to receive the calls from many channels, the radio can
be programmed to scan these channels. At most there are 16
channels in each scan list. Each channel can use a scan list
together with others or alone.
9.1 Start/End Scan Function
You can press SCAN button directly or enable the scan
through the menu. When the scan function is started, icon
and your revert channel will display .
To Next Page
Loading...
