20
INSTALLATION
VALANCE INSTALLATION
Attach the valance to the valance clips, as shown.
Insert the top of the valance into the top of
the valance clip.
Rotate the valance down to snap it into place
onto the headrail.
TIP: Tap the valance at each clip to assure that the valance is securely attached to the valance clips and the clips are securely
attached to the headrail.
Traditional Valance
Outside mounts and non-flush inside mounts only: Use the valance corner brackets to
attach a return to each end of the valance.
Fit the tabs on the corner bracket into the notches on the valance and return.
Be sure the mitered corners are flush.
Headrail widths over 96" with two-piece valances: Lay the two pieces of
the valance on a flat surface and connect them by placing a dovetail bracket
at the seam.
Corner
Bracket
ont of
Valance
Valance
Return
(Cross-
Section)
Notc
Notc
Valance
Outside Mount
Inside Mount
Dovetail
Bracket
To Next Page
Loading...
