KitchenAid 5FGA - Attaching the Grinder;Strainer to the Stand Mixer

ENGLISH
USING THE STAND MIXER ATTACHMENT | 13
USING THE STAND MIXER ATTACHMENT
ATTACHING THE GRINDER/STRAINER TO THE STAND MIXER
1
Turn the Stand Mixer off and unplug.
3
Insert the attachment shaft housing
into the attachment hub, making
certain the power shaft fits into the
square hub socket. If necessary, rotate
the attachment back and forth. The
pin on the attachment housing fits
into the notch of the hub rim when
in the proper position.
4
Tighten the Stand Mixer attachment
hub knob until the attachment
is completely secured to the
Stand Mixer.
2
For Stand Mixers with a hinged attachment hub cover: Flip up to open.
For Stand Mixers with a removable attachment hub cover: Turn the attachment
knob counterclockwise to remove attachment hub cover.
W10863933A_01_EN_v09.indd 13 9/25/17 3:52 PM