16 | CARE AND CLEANING
CARE AND CLEANING
1
Completely disassemble the
attachment parts.
2
These parts are dishwasher safe:
grinder worms, strainer cone, strainer
tray, splash shield, ring, food tray and
combination food pusher/wrench.
CLEANING THE GRINDER/STRAINER ATTACHMENT
3
Hand wash these parts in warm,
sudsy water and dry thoroughly:
grinder body, knife blade, grinding
plates, spring and shaft assembly.
NOTE: Some foods may stain certain
parts. These stains may be removed by
using one of the following methods:
place the dishwasher-safe parts in the
dishwasher and use a cycle for normally
soiled dishes; or rub a small amount of
oil/shortening over the stains, and then
wash in warm, sudsy water and rinse.
TIP: A small bottle brush may be used to
help remove pulp from the strainer cone.
NOTE: To loosen the ring: if the ring
is too tight to remove by hand, slip the
combination food pusher/wrench over
the grooves, and turn counterclockwise
to release.
W10863933A_01_EN_v09.indd 16 9/25/17 3:52 PM
To Next Page
Loading...
