KitchenAid KDS-20A - User Manual

KitchenAkB.
BUILT-IN
DISHWASHER
MODEL KDS20A
INSTALLATION
INSTRUCTIONS
INSTALLER:
FINAL CHECK LIST
PLACEMENT OF DISHWASHER
0 1. Properly positioned-level, aligned and square with cabinet opening.
0 2. Anchored securely, either to cabinet or floor.
0 3. Installation debris removed from under dishwasher.
ELECTRICAL CONNECTION
0 1. Separate 115 volt, 60 hertz, 1 phase branch with a 15 ampere capacity protected by a
maximum of 15 ampere fuse size.
0 2. Dishwasher properly grounded.
0 3. All connections in conformance with local electrical code.
PLUMBING
0 1. Water supply at dishwasher: 20 to 120 P.S.I. pressure, temperature of 120” F. or higher
and l/2” O.D. (min.) copper tube.
0 2. Drain lines at least 5/8” O.D. copper tubing or suitable g/16” I.D. flexible tubing with
no tight bends (kinks) or other restrictions to prevent complete draining.
0 3. Compliance with all aspects of local plumbing code.
0 4. Make sure drain hose does not touch any electrical components or terminals.
OPERATIONAL
0 1. All internal packing material and labels and door pads removed.
Place detergent in both compartments of detergent dispenser, close covers and operate
dishwasher through complete LOW ENERGY cycle.
Check: Proper Fill-Water level approximately l-1/2” below center line of 4 Way Hydro
Sweep tubes. Complete Drain.
Detergent Dispenser-must operate automatically and completely dispense
detergent.
THANK YOU INSTALLER:
1. Complete Installation Check List.
2. Leave all literature (including Check List) for customer.
3. Notify dealer that electrical work and plumbing are completed.
1-Q
FOR DETAILED INSTRUCTIONS, FOLLOW METHODS DESCRIBED IN THIS FOLDER

Summary

Installer Final Check List

Placement of Dishwasher

Verify proper positioning, leveling, alignment, and anchoring.

Electrical Connection

Confirm correct voltage, phase, amperage, grounding, and code compliance.

Plumbing

Check water supply pressure, temperature, pipe size, and drain line.

Installation Procedures

Preliminary Rough-In

Covers initial preparation of the cabinet opening and roughing in connections.

Cabinet Opening Details

Provides dimensions for cabinet depth and reference lines for connections.

Hot Water Supply Line

Drain System Connection

Electrical Supply Line

Final Installation Steps

Positioning and Anchoring

Connect Water Supply

Connect Drain Line

Connect Electrical Power

Testing and Verification

Steps to run a cycle, check for leaks, and verify proper operation.

KitchenAid KDS-20A Specifications

General

Type	Built-In
Energy Star Certified	Yes
Wash Cycles	Normal, Heavy, Light, Rinse
Drying System	Heated drying
Color	Stainless Steel