LIST OF REQUIRED TOOLS
The following tools are necessary to service the
KitchenAid
®
Stand Mixer.
SnapRingPliers
StandardSlip‐jointpliers
#R2SquareBitScrewDriver
Softcleancloth
5/32Punch
7/16NutDriver
Hammer
Side(orDiagonal)Cutters(to
removewireties)
NeedleNosePliers(toma nipulate
wires)
PhillipsScrewdriverSet
Volt/OhmMeter
NOTE: Power drivers are not recommended for
servicing KitchenAid
®
countertop appliances.
The following equipment will greatly assist the
technician in servicing the KitchenAid
®
Stand
Mixer.
Cleanragsorshoptowels
Cushiontheserviceareato
keepfromscratchingthe
applianceordamagingthe
controls.Acleanshoptowelor
afoldedpapertowelwill
usuallyworkwellforthis
purpose.
Lowpressurecompressedairto
removedebrisfrom
components.
ElectricalRequirement
The Stand Mixer is designed for use with 120
VAC, 60 Hz (240 VAC, 50 Hz International) only.
It has a grounded plug and should not be
modified in any way. Do not use an extension
cord or an adapter with this Stand Mixer.
A short power supply cord is provided (with the
exception of the Commercial unit) to reduce the
risks resulting from becoming entangled in or
tripping over a longer cord. If the power supply
cord is too short, have a qualified electrician or
service technician install an outlet near the area
where the Stand Mixer will be used.
Testing the Stand Mixer
Theservicetechnicianwillhavetotestthe
performanceoftheStandMixertoidentifyand
diagnosetheproblem.Normalelectricaltesting
techniques,usingavolt/ohmmeter,aresufficientto
testtheStandMixerelectricalcomponents.
NOTE:RefertothePROBLEMGUIDEinthismanual
whileperforminganytest.
Reviewanydocumentationaccompanying
thefaultyStandMixer.
Performagroundcontinuitytestanda
dielectricwithstand(HiPot)testpriorto
pluggingtheapplianceintoanelectrical
outlet.