18
USING YOUR ACCESSORIES
IMPORTANT: Discs and adapters must be removed before removing bowls.
Installing/removing the prep bowl
5
After processing, remove the prep bowl
using the two finger grips.
1
To use the prep bowl, place into the
work bowl, using the two finger grips.
3
Place the desired disc on the power
shaft. Do not use any blades with the
prep bowl.
4
Install the work bowl lid, aligning
the tabs and locking it into place.
2
Place the adapter on the power shaft.
NOTE: The prep bowl can be used only with the discs and the dicing kit.
To Next Page
Loading...
