Kiturami TURBO-21 - 8. Maintenance Guide - Burner; 8-1 Burner Assembly Instructions

8. MAINTENANCE GUIDE
8 - 1. Assembly Instructions for Burner
1. Plug off the power cord.
2. Close the Oil valve connected with the oil tank.
3. Disassemble screws fixed on front panel and open
the panel.
1. Separate the connector plug from burner.
2. Remove two nuts on burner flange by spanner.
3. Separate the burner by pulling forward.
1. Replace the gasket fixed on flange with new one.
2. Check the status of Burner (interval and fixed state of
ignition rod) and assemble the burner on flange.
3. Fix the burner by tightening nuts.
4. Assemble the connector plug on the exact location.
1
Tool
27페이지