Kitvision explore 1080p - Page 19

36 37
Fixing the camera to a vented helmet
1. Fix the camera to the mount clip (i).
2. ThreadthesuppliedstrapsthroughtheslotsinaatorcurvedAdhesive
Mount(don’tremovetheadhesivelm)(ii).
3. Attach the camera assembly to the strap mount assembly by sliding it in
until it clicks into position.
4. Afterxingthecameratothemountcorrectly,usethestraptoxittothe
helmet. Adjust the length according to the helmet’s size, and then push the
clips down into position to lock the straps in place.
i
ii
C
Fixing the camera to a board/at surface
1. Ensure the surface is clean and dry before applying the adhesive mount.
2. Peeloadhesivepaperandstickthemountinthedesiredposition.
3. Fix the camera to the Mount Clip (i).
4. Attach the camera assembly to the Adhesive Mount (C) by sliding it in
untilit“Click”intoposition.
i
C
(“Click”)