Kitvision rush hd100W - Photography and Wi-Fi Basics; Taking Photos and Auto Rotation; Wi-Fi Connectivity Setup; Connecting to Computer via Wi-Fi

14 15
Taking photos
1. Turn on the camera by pressing the ‘Power’ button
.
2. Oncethecameraison,pressthe‘Power’button totakeaphoto.TheLEDwillashgreenandtherewillbeashort
vibration to indicate that the action was successful.
Note: The still photo function is disabled during video recording.
Note: The default photo mode is ‘Single Photo’. ‘Burst-Shot’ mode gives you 10 continuous photo shots to capture
thatunmissablemoment.‘TimeLapse’modecanbeutilizedtotakeaseriesofphotosat5,10,30or60-second
intervals. To change the mode, please refer to ‘Running the software’, page 19.
Note:Ifthecardisfull,thecamerawillvibrateforvesecondsandthegreenLEDwillashcontinuously.
Auto rotation
The camera has a built-in G-sensor that detects the camera orientation. By rotating your camera to 90°, 180° or 270°
from the default position (refer to the picture), the recorded view will be rotated to the same angle. This allows you to
mount the camera in different orientation without recording a rotated or inverted view. The video resolution will be
adjusted for 90° and 270°.
Note: This feature is available for capturing videos only, not still photos.
Note: Adjust your camera orientation before you start the video recording. The rotation feature will not be activated
during the recording.
Note: You can disable the auto rotation function under the ‘General Settings’ option in the software.
Using Wi-Fi
Turn on Wi-Fi
1. Press and hold the ‘Power’ button to turn on your camera.
2. Press the ‘Wi-Fi Power Button’ either on the camera body or on the back cover to turn on Wi-Fi. After a short vibration,
theblueLEDlightsuptoindicatethatWi-Fiispreparing.Itwilltakearound15-20secondsfortheWi-Fitobecome
readyandconnectable.TheLEDwillashwhentheWi-Fifunctionisactiveorconnected.
3. To turn off Wi-Fi, press the Wi-Fi power button either on the camera body or on the back cover. The camera will vibrate
and Wi-Fi will turn off.
Note: Wi-Fi will drain the camera battery more rapidly when activated. Turn Wi-Fi off if you are not using it to change
settings or upload content.
Connecting the camera to your computer
1. Turn on Wi-Fi.
2. GotoyourPC’sorMac’snetworksettingsandchooseWi-Fi.Searchthenetworkandndandclick‘ACTIONPLUS’.
3. Enter the password ‘123456789’ to connect to your camera.
4. OpenyourInternetbrowserandinput‘192.168.1.2’or‘action.plus’.Youcanthenviewthelesstoredonyourcamera.
Connect the camera to your smart device (browser)
1. Turn on Wi-Fi.
2. Gotoyourmobiledevice’snetworksettingsandchooseWi-Fi.Searchthenetworkandndandclick‘ACTIONPLUS’.
3. Enter the password ‘123456789’ to connect to your camera.
4. OpenyourInternetbrowserandinput‘192.168.1.2’or‘action.plus’.Youcanthenviewthelesstoredonyourcamera.
Video resolution 0° or 180° 90° or 270°
1080p 1920 x 1080 608 x 1080
960p 1280 x 960 720 x 960
720p 1280 x 720 416 x 720