Klarstein 10033600 - Page 115

115
EN
Problem Possible Cause Suggested Solution
The air conditioner doesn't
give off any air.
The air inlet or outlet of the
air conditioner is blocked.
Remove the blockade.
In heating mode, the room
temperature has reached
the temperature set on the
air conditioner.
After the room temperature
reaches the temperature
set on the air conditioner,
the unit stops blowing air.
The heating mode has just
been activated.
To prevent cold air from
being blown out in
heating mode, warm air is
delayed by a few minutes.
This is a normal process.
The air conditioner cannot
be operated.
There is a power failure. Wait until the power
failure is over.
The mains plug is loose. Insert the mains plug
correctly into the socket.
The ventilation switch is
defective or the fuse has
blown.
Have a qualied person
replace the ventilation
switch or fuse.
The wiring has
malfunctions.
Have the wiring replaced
by a qualied person.
The device was switched
on again immediately
after it was switched off.
Wait three minutes after
turning off the unit before
turning it back on.
The function setting of the
remote control is not set
correctly.
Reset the functions to their
factory defaults.