20
EN
TROUBLESHOOTING
• Please note, if a power failure occurs due to disconnection of the power cord, or
the off power button has been pushed off during an ice making cycle, small ice
chips may formed and lodge in the automatic shovel causing it to jam. If this occurs,
the ice chips may be removed by disconnecting the power cord and gently pushing
the shovel to the rear of the cabinet and removing the ice chips, then restarting.
• Please restart the ice maker by pressing Stop and then Start. If the Ice shovel does
not push the Ice into the Ice collector after the formed Ice drops from the evaporator
nger while at the same time the M light is on, check to see if the water tray is
horizontal or balanced. If not then adjust by pressing the Ice shovel lightly with your
nger. Then re-start the Ice maker.
Problem Possible Cause Suggested Solution
The compressor works
abnormally with a Buzzing
noise.
The voltage is lower than
recommended.
Stop the Ice maker and do
not restart until the voltage
is normal.
Water shortage indicator
light is on.
There is no water Fill with water, wait 3
minutes and press the
“ON/OFF’ button to
restart.
The pump is full of air Open the drain cap, and
let several drops water
runs out.
To Next Page
Loading...
