Klarstein HEKTOR - FILTER CLEANING; Grease Mesh Filter Cleaning; Grease Mesh Filter Installation

22
EN
FILTER CLEANING
Note: Cut off the power when u clean. No detached the lter around, or lead to the
lter scatter. If the plug wire or plug damage, must use the specic exible wire or get
it in service center.
Cleaning the grease mesh lter
The mesh lters can be cleaned by hand. Soak them for about 3 minute in water with a
grease-loosening detergent then brush it gently with a soft brush. Please do not apply
too much pressure, avoid to damage it . (Leave to dry naturally out of direct sun light)
Filters should be washed separately to crockery and kitchen utensils. it is advisable not
to use rinse aid.
Installing the grease mesh lter
• To install lters for the following four steps .
• Angle the lter into slots at the back of the hood.
• Push the button on handle of the lter.
• Release the handle once the lter ts into a resting position.
• Repeat to install all lters.
Aluminium lter