Klarstein Iceblock Prosmart 9 - Getting Started

28
EN
GETTING STARTED
1. Select a location where there is a power connection nearby.
2. Install the exhaust hose as shown in the two illustrations below and adjust the
position of the window.
3. Connect the exhaust hose as shown in the illustration with the exhaust hose (see
gure below) (only for models with integrated heater).
4. Plug the mains plug into a grounded AC 220 - 240 V~ (50/60 Hz) socket.
5. Press the power button to turn on the device.
Drain hose