EasyManuals Logo

Klipsch R-10SW User Manual

Klipsch R-10SW
15 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #12 background imageLoading...
Page #12 background image
EU
COMPLIANCE INFORMATION
Eligible
to
bear
the
CE
mark;
Conforms
to
European Union
Low
Voltage
Directive
2006/95/EC;
European Union
EMC
Directive
2004/108/EC;
European Union
Restriction
of
Hazardous Substances Recast (RoHS2) Directive 2011/65/
EC;
European Union
WEEE
Directive
2002/96/EC;
European
Union Eco-Design Directive 2009/125/EC;
European Union
Registration.
Evaluation,
Authorization
and Restriction
of
Chemicals (REACH)
Directive
2006/121/EC
You
may
obtain
a free copy
of
the
Declaration
of
Conform
i
ty
by
contacting
your
dealer,
distributor,
or
Klipsch Group,
Inc.'s
worldwide
headquarters.
Contact
information
can be found
here:
http
:/
/www
.klipsch.com/Contact-Us
WEEE NOTICE
Note: This
mark
applies only
to
countries
within
the
European
Union (EU) and Norway.
~
This appliance is
labeled in accordance
with
European
A
Directive
2002/96/EC
concerning waste
of
electrica
l
- and
electronic
equipment
(WEEE). This
label indicates
that
th
is
product
should
not
be disposed
of
wi
th
household
waste.
It should
be deposited
at
an
appropriate
facility
to
enable
recovery and
recycling.
FCC
AND
CANADA EMC COMPLIANCE INFORMATION:
This device
complies
with part
15
of the
FCC
Rules.
Operation
is
subject
to
the
following two conditions:
(1)
This devi
ce
may not cause
harmful interference, and (2)
this device must accept any interference received,
including
interference
that
may cause undesired operation.
NOTE
: This equipment
has
been tested and found to
comply
with
the
limits
for
a
Class
B
digital
device, pursuant to part
15
of the
FCC
Rules.
These
limits
are designed
to
provide
reasonable
protection against
harmful
interference in
a
residential installation.
This equipment generates, uses and
can
radiate radio frequency energy and,
if
not
installed and used in
accordance with the instructions, may cause
harmful
interference
to
radio communications. However, there
is
no guarantee that
interference will
not occur in a particular installation. If this
equipment does cause
harmful
interference
to
radio
or
television

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Klipsch R-10SW and is the answer not in the manual?

Klipsch R-10SW Specifications

General IconGeneral
Frequency Response32Hz - 120Hz +/- 3dB
Maximum Acoustic Output112dB
Enclosure MaterialMDF
PhaseSwitchable 0-180 degrees
Auto Power On/OffYes
Amplifier Power150W RMS, 300W Peak
Driver10-inch
Enclosure TypeBass-reflex
InputsLine level/LFE RCA jacks
AmplifierDigital
Low Pass Crossover40-120Hz
Woofer10" (25.4 cm) spun-copper IMG woofer

Related product manuals