STYLE 140, STYLE 180, STYLE 220 PELLET STOVE
33
CLEANING AND MAINTENANCE
Precautions before cleaning
Before carrying out any cleaning or maintenance operations, make sure that:
- the appliance is off and has cooled down completely;
- the ash is completely cold.
- the rear switch (“Anti-interference filter”) is set to “0” (off).
- the ash vacuum device used for cleaning is suitable and its filter is in good condition.
Before re-starting the appliance, re-install all previously removed components, and check the tightness of the seals.
During cleaning operations, use the personal protection devices specified in Directive 89/391/EEC.
The frequency for cleaning depends on the type and quality of pellet burnt; therefore, the indicated times may change.
Any problem affecting the appliance caused by lack of cleaning will not be covered by the warranty. The failure
of these operations could affect the safety of the product.
Cleaning operations may be carried out by the end user, as indicated in the paragraph below.
Routine cleaning
The routine cleaning of the appliance must be done at least every 5 days of operation or after 20 ignition cycles, so as to
always guarantee efficient performance and optimal operation. Please proceed as follows:
Use the dedicated cleaning hook for the front scraper to operate the front rod, moving it forward and backwards to clean
off combustion residues from the air exchanger (Figure 1). Also operate the two upper knobs, moving them from the
bottom upwards to clean the internal flue gas turn (Figure 2).
To Next Page
