MEP-4xxx Direct-Coupled Actuators (40 to 90 in-lb.) 6 Applications Guide, AN0513A Rev. J
The HCO-1151 enclosure kit (consisting of a metal
mounting plate, plastic cover, non-rotation bracket,
plug caps, and screws) is designed to protect actua-
tors from inclement conditions. See also the HMO-
4521 liquid-tight cord grip.
An HMO-4521 liquid-tight cord grip threads into
conduit ings on MEP-4xxx actuators (except the
MEP-4003) when an ingress protection rating of
IP54 is required. The HMO-4521 accepts 0.18 to 0.40"
diameter cables. There are ve per pack. See also the
HCO-1151, HPO-4001, and HPO-4051.
Enclosure, Cord Grip, and Wiring Kits
An HPO-4001 assembled wiring kit has an HMO-
4521 liquid-tight cord grip, a 3-foot plenum-rated
cable, conduit ing, and a pre-wired terminal block
for the following actuators:
• MEP-4001
• MEP-4002
• MEP-4801
• MEP-4802
NOTE: It is not compatible with the MEP-40x3,
MEP-402x, MEP-4813, and MEP-482x
actuators. However, the HMO-4521 cord
grip can be installed on those models
(except for the MEP-4003) to provide IP54-
rated ingress protection.
An HPO-4051 assembled wiring kit has an HMO-
4521 liquid-tight cord grip, a 3-foot plenum-rated
cable, and a conduit ing for the following actua-
tors:
• MEP-4201
• MEP-4501
• MEP-4901
• MEP-4x51
• MEP-4x52
• MEP-4x54
NOTE: It is not compatible with the MEP-4x55 and
MEP-4x7x actuators, which are pre-wired
with cables. However, the HMO-4521 cord
grip can be installed on those models to
provide IP54-rated ingress protection.
To Next Page
Loading...
