KME Diego G3 - Starting the Engine

Page 2 / 8
ver. 1.3.2 04-12-2019
KME Sp. z o.o.● ul. Św. Teresy od Dzieciątka Jezus 103A● 91-222 Łódź● Office: Aleksandra 24/26 93-418 Łódź ●
tel +48(42) 611 00 26 ● fax +48(42) 611 82 52 ●
www.kme.eu ● NIP: 732-199-00-33 ● REGON: 473207460 ●
Nr KRS: 0000181402
Table of contents
1. STARTING THE ENGINE .................................................................................................................... 2
2. CONTROL PANEL .............................................................................................................................. 3
2.1 Indication of the current level of gas fuel in the tank (A) ....................................................... 4
2.2 Light sensor (NEVO and NEVO-SKY only) ................................................................................ 4
2.3 Gas system signaling ................................................................................................................ 4
2.3.1 Errors flashing codes (NEVO and NEVO-SKY only) .......................................................... 5
2.3.2 Acoustic signalization ...................................................................................................... 6
2.4 Additional control panel messages in NEVO and NEVO-SKY system ...................................... 6
2.5 Emergency start on gas ........................................................................................................... 7
2.6 Automatic gas level indicator calibration (NEVO and NEVO-SKY only, for NEVO available
from 4.0D version) ............................................................................................................................... 8
1. STARTING THE ENGINE
Vehicle equipped with Diego G3 / NEVO system normally starts on gasoline. Switching
to gas fuel supply occurs automatically after obtaining the relevant parameters, selected
during the calibration of the system, such as:
• coolant / reducer temperature,
• the delay time of switching petrol → gas,
• engine speed (RPM) for switching.